H30 CROSS ROOF RACK
Roof rack
It is a must to install additionally
transverse support xing rod no matter
what kinds of objects are transported on
the roof (such as bicycle frame and ski
carriers).
It is prohibited to hook or bundle the
objects at any other places rather than
the roof rack.
Suggestions
– When handling objects, neither
damage the antenna, nor contact the
roof to avoid scratching the vehicle
paint;
– Distribute the load uniformly to avoid
overload on one side;
– The part loaded with the heaviest
object should be as close to the middle
of the roof as possible;
– Bundle up the loads tightly with a rope;
if the object is too large, make marks
correspondingly;
– After loading the objects, the sensitivity
to the inuence of the side wind
force will increase and the vehicle
gravity center will rise. Please drive
the vehicle prudently (as the vehicle
stability may change);
– Once the transport i s nished,
disassemble the transverse support
xing rod mounted on the roof rack
immediately.
Note:
The maximum load distributed on
the roof rack should not be more
than 20kg and the maximum loading
height should not be more than 40cm
(except for the bicycle frame). If this
height is exceeded, control your
driving speed according to the road
condition, so as to avoid damaging
the roof rack or possibly inuencing
the driving safety.
Please observe the relevant
national transportation rules when
transporting the over-long and over-
wide objects.
Note:
The H30 CROSS is of crossover,
with its shape in the SUV sporty
style.
However, during the actual driving,
please be careful and do not perform
offroad driving to avoid vehicle
damage.
To Next Page
Loading...
Need help?
General
