IKEA DISKAD User Manual

35
Arrange tableware
Arrange the tableware correctly to op-
timise the dishwashing result and pre-
vent damage to both the appliance and
tableware.
Tips
● Using the appliance allows you to
save energy and water compared to
washing-up by hand.
● To save energy and water, load the
machine with the number of place
settings specified.
→"Technical specifications", Page58
● For better washing and drying res-
ults, position items with curves or re-
cesses at an angle so the water can
run off.
1. Remove large remnants of food from
your tableware.
To save resources, do not pre-rinse
tableware under running water.
2. Observe the following when arran-
ging tableware:
– Put heavily soiled tableware in the
bottom basket, e.g. pans. The
more powerful the spray jet, the
better the dishwashing result will
be.
– To prevent damage to tableware,
arrange it so it is stable and can-
not tip over.
– To prevent injury, arrange cutlery
with the points and sharp edges
downwards.
– Position containers with the open-
ings facing down so no water can
collect in them.
– Do not block the spray arms -
make sure that they can turn
freely.
– Do not place small parts in the
tablet collecting tray and do not
block it with tableware so as not to
obstruct the lid of the detergent
dispenser.
Removing tableware
WARNING
Risk of injury!
Hot tableware can cause burns to the
skin. When hot, tableware is sensitive
to shock, may crack and can result in
injury.
● When the programme has ended, do
not empty the appliance until the
tableware has cooled down for a
while.
1. To prevent water dripping on the
tableware, unload it starting at the
bottom and working up.

IKEA DISKAD Specifications

General

Type	Built-In
Number of Place Settings	13
Noise Level	44 dB
Voltage	220-240V
Dimensions	60 x 82 x 55 cm