13
Installing the appliances
When all countertop sections are secured and you’ve
given the silicone time to seal all edges of the
cut-outs, it’s time to start installing your appliances.
Throughout the installation, be sure to follow the
with the appliances.
Most extractor hoods at IKEA can be installed in two
ways: either in extraction mode (i.e. ducted to the
cabinet preparation is described in the assembly
instruction of your extractor hood.
Most of the appliances that you will work with for
ENHET is free-standing so they will be easy to slide in
place. But for the dishwasher and hoods, you need to
put in more work.
NOTE! All water, gas and electricity connections must
local safety regulations.
Before you install your extractor hood, make sure
cooktop and extractor hood that is listed in the
assembly instruction. Again, we recommend that
you get help from someone who can help you hold
and mount the hood while you make the required
preparations.
As you prepare for the dishwasher installation, keep
underneath the dishwasher. Required or not, it is a
In order to protect the bottom side and edges of the
countertop from the steam released when opening the
countertop.
After the dishwasher has been connected to water and
electricity, follow the dishwasher installation guide to
adjust the height of the dishwasher.
Once the dishwasher is level with the adjacent cabinets,
secure the dishwasher by following the instructions in
the dishwasher installation guide.
To Next Page
Loading...
