IKEA ENHET - Check wall support and alignment; Prepare workspace and check corners

5
Preparing your room
The wall studs, normally located 16” and/or 24” apart,
can carry the load of your wall cabinets/frames.


frames and position of the studs won’t align.
In order to provide proper support for the cabinets/
frames, you might need to add horizontal structural
support between the studs. As this requires the proper
skills, be sure to contact a professional for help.
NOTE! Even if your new cabinets/frames will be located
at the same position as your old ones, it is important to
secure that the walls have been properly reinforced.


mark where that is on the wall. This will be the
reference point from which to measure when marking
the key measurements.
Prepare your space by making sure your corners are

square for the corners and a spirit level for the walls

If your corner and/or walls aren’t straight you may need
to use shims to make sure your kitchen cabinets/frames
become level and align properly. For advice contact
your local specialized dealer.