IKEA finputsad Instruction Manual

ENGLISH 29
Whattodoif...
After-SalesService
Problems... Possiblecauses... Solutions...
Thedishwasherdoesnotll
thewater.
Displayshows:H
6andOn/OLEDisblinking
rapidly
No water in the water supply or
the tap is closed.
Make sure there is water in the water supply or the tap
running.
The inlet hose is bent. Make sure the inlet hose is not bent (see INSTALLATION)
reprogram the dishwasher and reboot.
The sieve in the water inlet hose
is clogged; it is necessary to
clean it.
After having carried out the verication and cleaning, turn o
and turn on the dishwasher and restart a new program.
Dishwashernishesthe
cycleprematurely.
Displayshows:5(15)and
On/OLEDisblinking
rapidly
Drain hose positioned too low
or siphoning into home sewage
system
Check if end of drain hose is placed at correct height (see
INSTALLATION). Check for siphoning into home sewage
system, install air admittance valve if necessary.
Air in water supply Check water supply for leaks or other issues letting air inside.
Thedoordoesn’tlock.
Racks are not inserted
completely
Verify that racks are inserted completely..
The door lock is not engaged. Vigorously push the door until you hear the “clack” sound.
Disheshavenotbeendried.
Selected program has no drying
phase.
Verify in the programs table if the selected program has
drying phase.
Rinse aid has run out or the
dosage is not adequate.
Add the rinse aid or adjust the dosage levels higher (see
FILLING THE RINSE AID DISPENSER).
Dishes are made of non-stick or
plastic.
The presence of drops of water it is normal (see TIPS).
Dishesandglassesshow
limescaleorawhitishlm
Salt level is too low. Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
Adjustment of the water
hardness
is not adequate.
Increase the values (see WATER HARDNESS TABLE).
Cap of the salt reservoir is not
properly closed.
Check the salt reservoir cap.
Rinse aid has run out or the
dosage is insucient
Add the rinse aid or adjust the dosage levels higher.
Dishesandglasseshavea
bluishtingeorbluestreakes
Rinse aid dosage is excessive Adjust the dosage rates to lower values.
If, after carrying out the above checks, the fault persists,
disconnect the mains plug and turn o the water tap. Contact
the After-sales Service (see warranty).
Before contacting our After-Sales Service, take note of the
following:
- the description of the fault,
- the appliance type and model,
- the service code (the number indicated on the adhesive
rating plate) inside the door on the right-hand side:

IKEA finputsad Specifications

General

Brand	IKEA
Model	finputsad
Category	Dishwasher
Language	English