Removing the residues and stubborn
residues
Food containing sugar, plastics, or tin foil
residues should be removed at once. A
scraper is the best tool for cleaning the glass
surface. It is not supplied with the appliance.
Place a scraper on the hob surface at an
angle and remove residues by sliding the
blade over the surface. Clean the appliance
using a damp cloth and some dish soap.
Finally, wipe the glass surface dry with a
clean cloth.
Limescale rings, water rings, fat splashes, or
shiny metallic discolourations should be
removed after the appliance has cooled
down. Use only a specialised cleaner for
glass ceramic or stainless steel.
Troubleshooting
Warning! Refer to Safety
chapters.
What to do if...
Problem Possible cause Remedy
You cannot switch on the ap‐
pliance or operate it.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec‐
tion diagram.
The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again and
again, contact an authorised
installer.
You did not set the power
setting in less than 10 sec‐
onds.
Switch on the hob again and
set the power setting in less
than 10 seconds.
You touched 2 or more sym‐
bols at the same time.
Touch only one symbol at a
time.
There is water or fat stains
on the control panel.
Clean the control panel and
wait for a few seconds before
activating again.
An acoustic signal sounds
and the hob switches o.
An acoustic signal sounds
when the hob is switched o.
You put something on one or
more symbols on the control
panel.
Remove the object from the
symbols.
The appliance switches o. You put something on the
symbol .
Remove the object from the
symbols.
ENGLISH 16
To Next Page
Loading...
