Adjacent walls, cupboards and protection
for combustible materials: Ensure that the
appliance is installed in accordance with
clauses 6.2.5 and 6.10.1.1 of AS/NZS
5601.1, or clauses 6.9.1 and 6.9.5 of
AS/NZS 5601.2 with regard to clearances
to combustible surfaces and materials, and
clearances to rangehoods and exhaust
fans. To ensure clearances of 200mm from
burners to vertical combustible surfaces
observe the minimum distance requirements
shown in Figure. Clearances to combustible
surfaces wmay be reduced if combustible
surfaces are protected in accordance with
clause 6.10.1.2 of AS/NZS 5601.1, or
clause 6.9.2 of AS/NZS 5601.2
For installation into a standard
600mm width benchtop the
clearance specified can not be
achieved and combustible
surfaces must be protected in
accordance with the above
clauses.
Electrical connection
Warning! Refer to Safety
chapters.
Connection cable
Caution! Information for
authorised installer only.
Warning!
The appliance must be earthed.
Warning!
Risk of injury from electrical
current.
• The electrical mains terminal is under
voltage.
• Make sure that the electrical mains
terminal is free of voltage.
• Loose and inappropriate plug and
socket connections. May overheat the
terminal.
• Make sure that the clamping connections
are installed correctly.
• Secure the cable with the strain relief
clamp.
Before connecting, check that the nominal
voltage of the appliance stated on the
rating plate, corresponds to the available
supply voltage. Also, check the power
rating of the appliance and make sure that
the wire is suitably sized to suit the
appliance power rating. Refer to the
Technical data chapter.
ENGLISH 16
To Next Page
Loading...
