EasyManua.ls Logo

IKEA MEDELNIVA - Page 18

IKEA MEDELNIVA
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Surface light replacement
CAUTION
CAUTION
To avoid risk of personal injury or property damage,
wear gloves when replacing the light bulbs.
To avoid risk of personal injury or property damage,
wear gloves when replacing the light bulbs.
main circuit breaker.
the microwave.
3.
Remove the LED light mounting screw.
4.
Unplug the LED light from the harness, replace with
Then reconnect the harness.
5.
Re-install LED light and mounting screw.
When re-installing mounting screw be careful not to
damage the LED light.
6.
Re-install LED light cover and mounting screw.
7. Plug the microwave back into the power supply or
turn the power back on at the main circuit breaker.
to the other side. The lter will drop out. Repeat for
detergent. Rinse well and shake to dry or wash in Do
not use ammonia. The aluminum on the lter
will corrode and darken.
Reinstall the 2nd lter using the same procedure.
Surface lights
Front
Tab
Rear
ODOR REMOVAL
Occasionally, a cooking odor may remain in the
microwave oven. To remove, combine 1 cup water,
grated peel and juice of 1 lemon in a 2-cup glass
measuring cup.
Boil for several minutes using 100% power.
Allow to set in microwave oven until cool. Wipe interior
with a soft cloth.
TURNTABLE/TURNTABLE SUPPORT
The turntable and turntable support can be removed
for easy cleaning. Wash them in mild, sudsy water; for
stubborn stains use a mild cleanser and non-abrasive
scouring sponge. They are also dishwasher-proof. Use
upper wirerack of dishwasher. The turntable motor shaft
is not sealed, so excess water or spills should be wiped
up immediately.
Cleaning the grease filters
The grease filters should be removed and cleaned often;
To order parts call (833) 337-4006
generally at least once every month.
Grease filter part number 5304478913
Grease lters
1. To remove the grease lters, slide the filter
the 2nd lter.
to the rear. Then pull lter downward and push
2. Soak the grease lters in hot water using a mild
2. Remove the LED li ght cover moun ting screw under
3. To reinstall the grease lter, slide it into the side
1. Unplug the microwave oven or turn off power at the
slot, then push up and toward oven to lock.
part 5304499540.To order parts call (833)337-4006.
18
EN

Related product manuals