6.
When the set time ends, the symbol
or and the set time flash. The acous-
tic signal sounds for two minutes. The
appliance deactivates. Press a button
or open the appliance door to stop the
signal.
If you press
while setting the time
for Duration
, the appliance
switches to setting the End
function.
Setting the Minute Minder
Used to set a countdown time. The maxi-
mum time you can set is 2 hours 30 minutes.
This function has no effect on the operation
of the oven. You can set the Minute Minder
at any time, also if the appliance is off.
1.
Press
again and again until and
00 flash in the display.
2. Press + or - to set the Minute Minder. At
first the time is calculated in minutes
and seconds. When the time you set is
longer than 60 minutes, the symbol
comes on in the display. The appliance
then calculates the time in hours and
minutes.
3. The Minute Minder starts automatically
after five seconds.
4. When the set time ends, the acoustic
signal sounds for two minutes. 00:00
and
flash in the display. Press a but-
ton to stop the signal.
If you set the Minute Minder when the
Duration
or End function oper-
ates, the symbol
comes on in the display.
Count Up Timer
Use the Count Up Timer to monitor how
long the oven operates.
Press
again and again until the display
shows time without clock symbols.
You cannot use the Count Up Timer
when the Duration
or End func-
tion operates.
Using the accessories
Warning! Refer to the Safety chapters.
Telescopic runners
Installing the telescopic runners
You can put the telescopic runners on each
level.
Make sure that the two telescopic runners
are on the same level.
The stop element (A) that is at one end of
the telescopic runner must point up.
1 2
A
Using telescopic runners
With telescopic runners you can put in and
remove the shelves more easily.
ENGLISH 11
To Next Page
Loading...
Need help?
General
