IKEA RAGLANDA - Specific Issues and Solutions; After-Sales Service

15ENGLISH
Problems... Possible causes... Solutions...
The dishwasher
does not ll the
water.
Display shows: H,
6 and On/O
LED is blinking
rapidly
No water in the water supply or the tap is
closed.
Make sure there is water in the water supply or the tap running.
The inlet hose is bent.
Make sure the inlet hose is not bent (see INSTALLATION) reprogram
the dishwasher and reboot.
The sieve in the water inlet hose is clogged;
it is necessary to clean it
After having carried out the verication and cleaning, turn o and
turn on the dishwasher and restart a new program.
Dishes have not
been dried.
Selected program has no drying phase.
Verify in the programs table if the selected program has drying
phase.
Rinse aid has run out or the dosage is not
adequate.
Add the rinse aid or adjust the dosage levels higher (see FILLING
THE RINSE AID DISPENSER).
Dishes are made of non-stick or plastic. The presence of drops of water it is normal (see TIPS).
Dishes and
glasses show
limescale or a
whitish lm.
Salt level is too low. Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
Adjustment of the water hardness is not
adequate.
Increase the values (see WATER HARDNESS TABLE).
Cap of the salt reservoir is not properly
closed.
Check the salt reservoir cap.
Rinse aid has run out or the dosage is
insucient.
Add the rinse aid or adjust the dosage levels higher.
Dishes and glas-
ses have a bluish
tinge or blue
streakes.
Rinse aid dosage is excessive. Adjust the dosage rates to lower values.
After-Sales Service
If, after carrying out the above checks, the fault persists, discon-
nect the mains plug and turn o the water tap. Contact the
After-sales Service (see guarantee).
Before contacting our After-Sales Service, take note of the
following:
• the description of the fault,
• the appliance type and model,
• the service code (the number indicated on the adhesive
rating plate) inside the door on the right-hand side: