IKEA RENGJORD - Controls and Settings: Status and Errors; Status Window and Error Codes

8
EN
CONTROLS & SETTINGS
In all Error Code instances, if pressing the Cancel button or turning power o at the breaker
for 5 min. does not solve the problem, contact the Authorized Service Center stated in the
warranty section.
Error Code
Displayed
Error Code*
Problem Solution
i10 A low ll has been
detected.
Look for a pinched water supply line, or water
shuto is not completely opened.
i20; i40; iF0 Clogged lters or a
restricted drain line has
been detected.
Check and clean both lters and sump
area and check for a pinched or blocked
drain hose. If the drain line is attached to a
disposer, check that the knockout plug has
been removed.
i30 A leak or overow of
water has been detected
in the bottom pan.
Look for loose connections at the water inlet
valve and ensure the unit is properly leveled.
i50 A problem has been
detected with the drain
or wash motor.
Pressing the cancel button or turning power
o at the breaker for 5 min. should clear this
error code and the unit can be restarted.
If this does not resolve the problem,
service will need to be called.
i60 A problem has been
detected with the water
heating system.
iC0 A problem has been
detected with the
electronic control system.
Status Window
The STATUS window, available on some models, indicates the following activity:
User Instruction Code
1-24h Number of delay start hours.
The last hour will count down
in minutes.
CLOSE Close will scroll across the
status window indicating the
door needs to be closed.
MINUTES Number of minutes left in
cycle (1-199).
L0–L6. Level of Rinse Aid dosage.
Instruction
Code
Displayed
Problem/Condition Solution
Close This indicates the door
has been left open or
not properly latched.
Ensuring the door is properly latched will clear
the display. This does not indicate a problem
with your dishwasher and service will not need
to be contacted.
PF Soft Power Failure: PF is displayed if a power outage occurs during a wash
cycle. The wash cycle will be paused temporarily and resume once power is
restored if the door has not been opened.
Hard Power Failure: A hard power failure means the unit will not operate
until power is restored. Pressing start within 18 hours of loss of power will
resume power at the point of cycle interruption.