ARCING
Arcing is the microwave term for sparks in the oven.
Arcing is caused by:
• Metal or foil touching the side of the oven.
• Foil not molded to food (upturned edges act like
antennas).
• Metal, such as twist-ties, poultry pins, or gold-
rimmed dishes, in the microwave.
• Recycled paper towels containing small metal pieces
being used in the microwave.
Federal Communications Commission Radio
Frequency Interference Statement (U.S.A.
Only)
This equipment generates and uses ISM frequency
energy and if not installed and used properly, that is in
strict accordance with the manufacturer's instructions,
may cause interference to radio and television
reception. It has been type tested and found to comply
with limits for ISM Equipment pursuant to part 18 of
FCC Rules, which are designed to provide reasonable
protection against such interference in a residential
installation.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following:
• Reorient the receiving antenna of the radio or
television.
• Relocate the microwave oven with respect to the
receiver.
• Move the microwave oven away from the receiver.
• Plug the microwave oven into a different outlet so
that the microwave oven and the receiver are on
different branch circuits.
The manufacturer is not responsible for any radio
or television interference caused by unauthorized
modication to this microwave oven. It is the
responsibility of the user to correct such interference.
UNPACKING AND EXAMINING YOUR
MICROWAVE OVEN
Open the bottom of the carton, bend the carton aps
back and tilt the microwave oven over to rest on
plastic foam pad. Lift carton off microwave oven and
Wall Template,Top Template, Filter,Turntable and
Turntable Support. SAVE THE CARTON AS IT MAY MAKE
INSTALLATION EASIER.
• Remove the feature sticker from the outside of the
door, if there is one.
• DO NOT REMOVE THE WAVEGUIDE COVER, which is
located on the ceiling in the microwave oven cavity.
Wall Template, Top Template and Filter, which is used
when recirculating is chosen.
Check the microwave oven for any damage, such as
misaligned or bent door, damaged door seals and
latches and dents inside the cavity or on the door. If
there is any damage, do not operate the microwave
GROUNDING INSTRUCTIONS
This appliance must be grounded. This microwave
oven is equipped with a cord having a grounding wire
with a grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded in
accordance with the National Electrical Code and local
codes and ordinances. In the event of an electrical
short circuit, grounding reduces risk of electric shock by
providing an escape wire for the electric current.
Consult a qualied electrician or serviceman if the
grounding instructions are not completely understood,
or if doubt exists as to whether the appliance is properly
grounded.
Electrical Requirements
the power supply.
The electrical requirements are a 120 volt 60 Hz, AC
only, 15 amp. or more protected electrical supply. It is
recommended that a separate circuit serving only the
microwave oven be provided.
The microwave oven is equipped with a 3-prong
grounding plug. It must be plugged into a wall
receptacle that is properly installed and grounded. DO
NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE
THE GROUNDING PIN FROM THE PLUG.
DO NOT USE AN EXTENSION CORD.
A short power supply cord is provided to reduce the
risks resulting from becoming entangled in or tripping
over a longer cord.
WARNING
Improper use of the grounding plug can result in a
risk of electric shock.
IMPORTANT SAFETY INSTRUCTIONS
remove all packing materials, Assembly Instructions,
Check to see that there are Assembly Instructions,
oven and contact any IKEA Store.
sealing surfaces, broken or loose door hinges and
See Assembly Instructions for more details.
Check Assembly Instructions for proper location for
EN
Read enclosures and SAVE the User Manual
.
Safety door
latches
Door seals and
sealing surfaces
Waveguide
cover
Hinges
Oven cavity
To Next Page
Loading...
