IKOHS CREATE LIGHTCALM - Step 5. Assembling the Blades

ENENGLISH
Once docked in the hole, turn piece I to the right and check that it is properly seated
without pinching any wires.
Once piece I K into the remaining holes by tightening them

With the motor well posi-
tioned, we will begin the
assembly of the blades F.
    F securing it with the washers and
screws J with the help of the screwdriver, without tighten-
ing them too much, to be able to put the rest of the blades.
STEP 5. ASSEMBLING THE BLADES
F J
A replacement
screw is included
+
F F
J
J
4
7
1
5
8
2
6
9
3
I