IKOHS CREATE LIGHTCALM - Blade Balancing Kit

ENENGLISH
BLADE BALANCING KIT
G
Your ceiling fan may have blade swing problems when in operation due to irregularities
in the blades or brackets. Also, incorrect system mounting or crooked bearings could
cause additional problems. The following procedure is recommended to remedy these
problems:
1. 
2. 
inclination of the blade mounts, they should all be the same.
3. Standing under the fan and looking up, check that none of the blade supports are
bent so that none of the blades are misplaced. You can correct the position of the
blade holders by gently bending them to the correct position.
4. You can check the height of the blades with a simple school ruler. Place the ruler
against the ceiling vertically and level with the outside of the blade tip. Check the
distance from the blade tip to the ceiling, carefully rotate the blades by hand and
check the rest of the blades. If the blades are not aligned, you can carefully bend
the blade holder up or down slightly to align with each other.
If the balance problem is not solved even by following the steps above, you must
perform a dynamic balance check using the kit provided. Follow the procedure below:
1. Turn on the fan and set the speed at which the most sway is created (usually this
occurs at the highest speed).
2. Turn off the fan. Select a blade and place the balancing clip, midway between the
bracket and the tip, on the rear edge of the blade.
3. Turn on the fan. Wait to see if the sway has improved or worsened. Turn the fan off
again and attach the clip to another blade to retest. Repeat this process with all the
blades and check which one has improved the most.
4. Place the clip on the blade that has improved the most. Move it in or out of the

roll improvement.
5. Then remove the clip and install a balancing weight on top of the blade on the
center line near the position where the clip was placed. Use a knife or blade if nec-
essary to separate the weights.
Caution: Stand at a safe distance from the blades. If for any reason the clip has not
been properly secured, you could be injured.