EN ENGLISH
STEP 1. CONCRETE CEILING
(1) EXPANSION SCREWS
Using a drill, make the two correspond-
ing holes with a Ø8 mm drill bit.
Insert the pieces E1 in the holes of the
ceiling.
Place piece A matching its holes with
the screws E. Make sure the ceiling ca-
bles pass through the center hole of
piece A.
Mark 2 parallel holes on the ceiling with
a pencil using piece A as a guide.
A
E1
E1 E2 E3 E4
Disassemble piece E separating it into pieces.
E
A
EA
PARTS AND TOOLS
Ø8 mm
1
3
2
4
+ +
NOT INCLUDED
To Next Page
Loading...