recharge the battery at least once a month in order to keep the internal
battery working properly.
Charging in Unit Power OFF mode
The Indicator LED is RED while charging.
The Indicator LED will turn off automatically when the battery is fully
charged.
Battery Note and Care
Do not burn or bury batteries.
Do not puncture or crush.
Do not disassemble.
Lithium batteries must be recycled. Do not dispose of in the trash.
Use only chargers rated for Li-ion cells. Be sure the charger’s voltage and current
settings are correct for the battery pack being charged.
Charge batteries on a fireproof surface and away from flammable items or liquids.
Batteries should NEVER be left unattended while charging. Only adults should
charge the batteries.
Follow the manufacturer’s instructions for charging the product and do not charge
longer than recommended. Unplug the charger when the battery is charged or not in
use.
NOTE: The Speaker is not magnetically shielded and may cause colour distortion on the
screen of some TVs or video monitors. To avoid this, you may need to move the unit further
away from the TV or monitor if an unnatural colour shifts or image distortion occurs.
ON/OFF
1. Hold down the function button for 5 seconds to turn the unit ON. The LED Indicator will
flash blue for 5 seconds, and there will be an Audio Notification to indicate that it is now
ON.
2. To turn the unit OFF, hold the function key for 5 seconds. The LED Indicator will flash red
for one second, and there will be another Audio Notification. Don’t forget to turn off the
Bluetooth feature on your cell phone.
SPEAKER OPERATIONS
PAIRING (LINKING) A BLUETOOTH ENABLED MOBILE PHONE OR OTHER BLUETOOTH
ENABLED DEVICE TO THE MXSP-BTS150
1. If the IKUtrax has never been paired with a Bluetooth device before. You need to follow
the pairing instructions below to link the speaker with your Bluetooth device.
Push and hold the centre button for 8 seconds. After 5 seconds the speaker will
indicate that it is on. Keep holding without releasing for another 3 seconds, and the
speaker will enter Pairing Mode. The Indicator LED will flash blue rapidly.
The Speaker is ready to pair (link) with your Bluetooth device.
Turn on the Bluetooth function of your mobile phone and enable the search or scan
function to find MXSP-BTS150.
Select MXSP-BTS150 from the device list when it appears on your device screen.
2. After turning on the IKUtrax, the unit will search for the last paired device. The LED
INDICATOR will flash rapidly in blue. If the unit finds the paired Bluetooth device, a beep
is heard and the LED INDICATOR will begin flashing at a slower rate.
3. After successfully pairing (linking), you can begin playing music from your Bluetooth
device wirelessly to the Speaker.
To Next Page
Loading...