4. Press the Volume Up (+) / Down (-) button on your Bluetooth device to adjust to the
desired volume level. Alternatively, press the “+” button on the speaker to increase the
volume. A beep alert sounds when the volume has reached the maximum level. Press the “-”
button to decrease the volume.
Notes:
1. Refer to the manual of your mobile phone, tablet, PC, computer or other Bluetooth
enabled device for Bluetooth operation, since it may vary from model to model.
2. Your Bluetooth enabled device will not play the music through the Speaker, even if
connected (linked), if the device does not support A2DP profile.
3. If you are pairing (linking) your computer to the IKUtrax using Bluetooth, you may
need to set the Speaker as your computer’s default sound device.
4. If the IKUtrax is left idle for about 5 minutes without linking to any Bluetooth enabled
device, the Bluetooth function will automatically turn off to save battery power.
Using IKUtrax as a Hands-free Bluetooth Speakerphone.
1. Link your mobile phone to the IKUtrax via Bluetooth as described above.
2. When receiving an incoming call on your mobile phone, press the Function key on the
Speaker to switch the incoming call from your mobile phone to the IKUtrax Speaker.
3. Adjust the volume control of the speaker to obtain the desired sound level.
4. To end the call, just press the function key again on your IKUtrax. A short beep sound will
be heard and the call will end. If you were playing music from your mobile phone to the
IKUtrax before answering the call, the music will automatically resume playing when you
hang up.
5. To ignore an incoming call, simply double click the function key.
Re-linking to the mobile phone
If your mobile phone is already paired (linked) with the Speaker, but became
unlinked even with both Bluetooth devices turned on, then you can re-link them by:
1. Turning off the Speaker and then turning it on again to re-link your mobile phone.
2. You can also re-link the Speaker by using Bluetooth operation on your mobile
phone. Please refer to the operation manual of your cell phone for more
information.
VOLUME CONTROL
Repeatedly press the “+” button to increase the volume. A beep alert sounds when volume
has reached the maximum level. Repeatedly press the “-” button to decrease the volume.
(Do not hold the “+” or “-“ buttons to change the volume, this will skip tracks)
REMOTE CONTROL MUSIC TRACKS
Press the function button to play or pause the current track. To change to a different song,
press the “+” or “-“ on the top of the speaker. You can also use your mobile device.
AUX-in JACK
Connect any music device by using the 3.5 mm cable included.
TAP TO LINK WITH NFC
Install the Android Apps provided to the NFC-equipped Smartphone. Simply align the NFC
LOGO and hold for 1-2 seconds to activate Bluetooth, pair the two devices, and stream your
music. ”Connect” is shown on the phone screen when MXSP-BTS150 is connected
To Next Page
Loading...