IKUtrax MXSP-BTS150 - Care, Troubleshooting, and Specifications; CARE AND MAINTENANCE; TROUBLESHOOTING

successfully. Tap again to disconnect two devices and the phone will show “Disconnect” on
the screen.
CARE AND MAINTENANCE
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
CLEANING THE UNIT
 To prevent fire or shock hazard, disconnect your unit from the USB port and power
source when cleaning.
 The finish on the unit may be cleaned with a dust cloth and cared for as other furniture.
Use caution when cleaning and wiping the plastic parts.
 If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or
polish sprays on the cabinet.
 If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a
soft cloth slightly dampened with a mild soap and water solution. Never use abrasive
cloths or polishes as these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
TROUBLESHOOTING
Symptom
Possible Problem
Solution
Not Charging
The USB power adaptor
(not included) is not
plugged into a wall outlet or
the USB cable (included) is
not plugged into the micro
USB jack on the side of the
IKUtrax.
Plug the USB power adaptor (not included)
into a wall outlet and plug the USB cable
(included) into the micro USB jack on the side
of the IKUtrax.
Wall outlet is not
functioning.
Plug another device into the same outlet to
confirm the outlet is working.
Computer USB port is not
functioning.
Make sure your computer power is turned on
and try another USB port.
No Sound
The IKUtrax battery is
dead.
Recharge the IKUtrax battery.
The IKUtrax is not linked
with your mobile phone.
Go through “Speaker Operations” process to
link the Speaker
The IKUtrax placement is
out of range.
Relocate the IKUtrax within Bluetooth
operating range 10 meter (33 feet).
Volume set too low.
Increase the volume of your device.
Sound is
distorted.
Volume level is set too
high.
Decrease the volume of your device.
Sound source is distorted.
If the source sound file is of poor quality,
distortion and noise are easily noticeable at
high volume level. Try a better sound quality
music file again.
Unit gets warm
after extended
play at high
volume.
This is normal.
Turn the unit off for a period of time or lower
the volume.