To Next Page

To Previous Page

1 Litro

1 Liter

321

If the light is blinking yellow, it is necessary

to descale the machine.

Turn o the machine and remove the capsule

holder.

Remove and  ll the tank with fresh drinking water

up to the MAX level. Pour the descaling solution

and stir.

Place a container of at least 1 litre capacity under

the co ee dispensing spout.

Turn on the machine. Within 15 seconds press and

hold the button for 4 seconds until you hear

the acoustic signal.

The light will blink yellow.

Within 2 minutes press the

button to start

the descaling cycle.

8 - DESCALING

Note: The descaling cycle may be

paused by pressing the

button. To

resume it, press the

button again.

Read all instructions carefully before performing the cycle in order to familiarise yourself with the process. Duration: about 20 minutes. NOTE: If the operations are not carried out

according to the indicated time, the machine will not start the descaling process. In this case, turn o the machine and repeat steps.

Limescale normally builds up with the use of the machine. Descaling allows to optimise cleaning and to remove limescale deposits from the inside.

If the descaling cycle is interrupted by a power failure or because the machine was turned o incorrectly, you must repeat the entire procedure before you can use the machine.