5
- To reduce the risk of injury, do not drape the cord over the coun-
tertop or table top where it can be pulled on by children or tripped
over unintentionally.
- In case of re, extinguish with carbon dioxide (CO
2
). Do not use
water or powder extinguishers.
- Never obstruct the vents on the base of the machine.
Installation of the machine
- Read the instructions carefully.
- Do not install the machine in an area where the temperature may
reach 0°C/32°F or lower (if water freezes, the appliance may be
damaged) or higher than 40°C/104°F.
- Check that the mains electric voltage corresponds to the require-
ments indicated on the machine data plate. Connect the machine
only to a properly grounded power outlet with a minimum rating
of 6 A for models powered at 230 Vac, and 15 A for models
powered at 120 Vac.
- If the plug and the outlet are not compatible, have the plug
replaced with a proper one by an authorized service center.
- Place the machine on a countertop away from water taps and
sinks.
- After removing the packaging, check that the appliance is in
perfect condition before installation.
- Do not leave the packaging materials within children’s reach.
Cleaning the machine
- Unplug the machine before cleaning.
- Wait until the machine is cool before cleaning.
- Remove the water tank by pulling it up slightly and then outward.
- Clean the body and attachments with a wet cloth and then wipe
with a non-abrasive dry cloth. Do not use detergents.
- Do not expose the machine to extended jets of water or immerse
it in water, partially or fully.
In case of malfunctioning
Do not use the appliance if the cord or plug are damaged or if the
appliance shows signs of malfunctioning or has been damaged in
any way. Take the machine to the nearest authorized service center
for checks or repairs.
If the power cord is damaged it must be replaced by the manufacturer
or an authorized service center.
In case of damage or malfunction, turn o the appliance and do
not tamper with it. For repairs contact a service center authorised
by the manufacturer and request the use of original spare parts
only. Failure to comply with these instructions may compromise
the safe operation of the machine and will result in the forfeiture
of warranty rights.
EN
To Next Page
Loading...
Need help?
General
