Ilsintech SWIFT KF4 - HOW TO TURN THE POWER ON;OFF; KF4 SLEEVE HEATER

4.2 | HOW TO TURN THE POWER ON/OFF
To power on the KF4, press and hold about 1 second with the wind cover closed. After the functions of
motors and initialize, the screen will display the following. Then splice and heater mode should be selected.
The current splice and heater mode are displayed at the bottom of the screen.
4.3 | KF4 SLEEVE HEATER
The sleeve heater of the KF4 reinforces the spliced point of the single
fiber. The quality of fusion splicing on the fiber should be good.
The fiber and inserted sleeve tube should be properly aligned and installed on the heater.
Close the heater cover while the heater is on.
ITEM DESCRIPTION
Cable diameter
250µm, 900µm, 2.0mm — 3.0mm
Sleeve length
Standard 32mm
Heating time
10 — 35 seconds
Temperature range
130°C — 200 °C
1| Choose the heater mode after the confirmation of the length for the sleeve tube when placing a sleeve tube
on a heater.
2| Place the spliced point in the middle of the sleeve tube first. Then, check the heating part on the heater and
place the sleeve tube on right position.
10