ILUMINAGE TOUCH - Device Power and Light Issues; Applicator Activation and Error Indicators

32
No lights are on. Connect power cable.Power cable is not connected.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
TROUBLESHOOTING
1.1.
All elōs energy setting
buttons on the base
are blinking
(HIGH-MEDIUM-LOW).
No elōs energy level was
selected.
Select an elōs level.1.1.
elōs activation button
on the applicator is
blinking.
Error light is on.
elōs energy level was selected
but elōs activation button was
not pressed yet.
Need to reset the system.
Press the elōs activation
button. The applicator fan
will start blowing indicating
that the elōs cartridge is
active.
1.
Reset the system by turn-
ing it o and on again.
If problem persists, discon-
nect power cord and
wait until all lights are o
(several seconds). Then
reconnect the power cord
and turn on the system.
If error light is still on, try
moving to a cooler area
with a room temperature
of less than 30°C/86°F and
restart the system.
1.
2.
3.
1.
1.