OPERATIONAL INSTRUCTIONS
Lighting Settings
Some applications may also allow you to adjust light settings other than those shown above. We
have dened some commonly used terms which may appear in software programs you are using:
Light Sources
· Lighting Modes - Your camera normally operates in normal mode; however, you can switch it to
dark mode when there is too much light or bright mode when light is dim.
· Banding Filter - If you are in a room lit by uorescent lighting, then please check that the
Banding Filter is being used, if present. Depending on the uorescent lighting system used in
your country, you will either choose a lter type of 50 Hz or 60 Hz.
· Color Temperature - The USB Web Camera’s default is normal mode, but you can switch it to
cool when your light source tends to be red or switch it to warm when your light source tends
to be blue.
· Compression Control - Compression control lets you adjust the frame rate. The USB Web
Camera is initially set to use the lowest compression setting, but choosing high compression
mode may help speed up the rate of transmission.
iLuv | 9iCM10/15/20 | V10M10_IM_EN_08112010
To Next Page
Loading...