ILVE IVFSD10X - Cancelling a Programme

EN - 0
Activated’ will show on the display.
-The new programme will resume the
course of the old programme.
7.3. Cancelling a Programme
Follow the steps below to cancel a
programme while in operation.
- Press and hold the Start/Pause button (5)
for 3 seconds.
- The display will count down 3 seconds
and show ‘Program Cancelling..X’. When
it finishes, ‘Program Finished’ will show on
the display.
-You can then select another programme,
additional functions or delay duration.
Settings Menu
To enter the Settings Menu, press and
hold the Option and Delay buttons (3, 4)
for 3 seconds.The display will show ‘Keep
Pressing ..X’. When this reaches zero, the
Settings Menu will show on the display. Use
the Up and Down Selection buttons (6, 7) to
navigate within the menu. To exit the menu,
simultaneously press and hold the Option
and Delay buttons (3, 4) for 3 seconds or
use the Confirmation button (2) to select
‘Exit Menu’.
The menu content is as follows:
1. Language
2. Water hardness
3. Volume
4. Brightness
5. Eco mode
6. Factory settings
7. Energy save
8. Exit menu
1. Language settings
Use the Up and Down selection buttons
to select the Language option in the
menu. The display will show ‘1.Language:
X’, where “X” represents the current set
language. Press the Confirmation button
(2) to activate the language selection. After
selecting the new language, press the
Confirmation button again to save it.
Available languages:
English
Turkish
French
Deutsch
Italian
Greek
Croatian
Russian
Finnish
Norwegian
Nederlands
Swedish
Dansk
Spanish
Portuguese
Polish
Czech
Slovene
Hungarian
2. Water hardness setting
Please see the section on water softening
setting (page 15).
3. Volume
Navigate to the ‘3- Volume’ option using
the Up and Down Selection buttons (6, 7).
The display will show ‘Volume: X’ where
X represents level 1, 2 or 3. Level 1 is the
lowest volume and level 3 the highest.
Press the Confirmation button (2) and
select the desired volume level. Press
the Confirmation button again to save the
selection.
4. Brightness
Navigate to the ‘4- Brightness’ option using
the Up and Down Selection buttons (6,
7). The display will show ‘Brightness:X’,
where ‘X’ represents level 1, 2 or 3. Level
1 is the lowest brightness level, and level 3
the highest. Press the Confirmation button
(2) and select the desired brightness level.
Press the Confirmation button (2) again to
save the selection.
5. Eco mode
This mode saves energy by dimming the
display brightness level after 30 seconds
of no activity. Navigate to the ‘5- Eco mode’
menu option using the Up and Down
Selection buttons (6, 7). The display will
show ‘Ecomode: X’, where ‘X’ is either
‘YES’ or ‘NO’. Press the Confirmation
button to activate ‘X’.
6. Factory Settings
Navigate to the ‘6- Factory settings’ using
the Up and Down Selection buttons (6, 7).
Select this option using the Confirmation
button (2) if you wish to restore all settings
to the factory default. The display will show
‘6. Factory settings: X’, where X represents