INSTALLATION
35
- Unpack the cooker and mount the feet by adjusting the height.
- Measure the height from the oor to the top edge of the back-cross bar (picture 5) and
add 15mm.
- Sign the total height on the supporting back wall at the centre of the cooker width.
Make a holeby means of a 6 diam. point and install the xing bracket (picture 6).
- Check that the cooker is leaning against the back wall to avoid tipping.
The anti-tilt system is assured only if the cooker is installed with the back part
leaned against the back wall.
Model: 60 & 90cm.
ATTENTION
INSTALLATION
- How to install the xing bracket
To Next Page
Loading...
