Image IMTL39105.3 User Manual (English)

Questions and Answers:

B
Benjamin JohnsonJul 30, 2025
What to do if Image Treadmill power turns off during use?
- J
  Juan ReynoldsJul 30, 2025
  If the power turns off during use, first check the circuit breaker located on the treadmill frame near the power cord. If the circuit breaker has tripped, wait five minutes, and then press the switch back in. Also, ensure that the power cord is properly plugged in; if it is, unplug it, wait five minutes, and then plug it back in. Finally, remove and reinsert the key from the console.
B
Brenda DanielsAug 7, 2025
What to do if Image IMTL39105.3 Treadmill walking belt is off-center or slips?
- A
  Alyssa SantiagoAug 7, 2025
  If the walking belt is off-center, remove the key and unplug the power cord. If the belt has shifted left, turn the left rear roller bolt clockwise 1/2 turn; if it shifted right, turn the left bolt counterclockwise 1/2 turn. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. If the walking belt slips when walked on, remove the key and unplug the power cord. Using the hex key, turn both rear roller bolts clockwise, 1/4 of a turn. When correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform.
H
hdunnAug 15, 2025
What to do if Image IMTL39105.3 walking belt slows when walked on?
- J
  Jason MillerAug 15, 2025
  Use only a single-outlet surge suppressor that meets all specifications. If the walking belt is overtightened, treadmill performance may decrease and the walking belt may become damaged. Remove the key and unplug the power cord. Using the hex key, turn both rear roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform.
M
Mason BrowningAug 21, 2025
How to recalibrate Image IMTL39105.3 Treadmill incline?
- J
  Joshua MooreAug 22, 2025
  With the key in the console, press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, reinsert the key. The treadmill will rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.