Fault description
5
If the charger detects a fault, an error will be diaplayed,indicated
by a ashing status LED (or LEDs) and an audible chime.
LiPo Status LED Flashes Red with Audible Chime
The balance connector has been unplugged during the
charging process.Press the Start/Stop/Select button to reset the
charger, then plug the balance connector back in and restart the
charging process.
LiPo Status LED Flaches Green with Audible Chime
The balance connector is not plugged in or has been plugged
into the incorrect balance port,Press the Start/Stop/Select button
to reset the charge,then plug the balance connector into the
correct balance port and restart the charging process.
LiPo and NiMH Status LED Flashes Red with Audible Chime
If charging a LiPo battery,the LiPo status LED will turn orange
when the battery is charged to 90% capacity,then will turn green
when charged to full capacity as described above.
The charging process can be stopped at any time by pressing the
Start/Stop/Select button.
4.After the charging process completes,unplug your battery from
the charger,then unplug the charger from its power source.
If the battery is left connected to the charger, an audible chime
will sound once every minute to remind you to remove the battery
from the charger. The charger does not trickle charge after the
charging process completes,as LiPo and NiMH batteries are
susceptible to damage if overcharged.
To Next Page
Loading...
