1903KITINT18_230 – 1903KITINT18_400 (E121001A_ENG) 26/10/2012
5
using some LOCTITE 243 to stop the
threads.
o) Control the four motor bolts correct
tightness.
p) If necessary, lower the motor support
group few millimeters to reach the
correct belt tension.
5.A INSTALLATION – MECHANIC
COMPONENTS FOR SERIAL NUMBER
HIGHER THAN E201402101
For dryers with serial number higher than
E201402101 the installation and the
adjustment of the engine support can be
done by using the bolts and the washer
provided with the kit (4936VIZN1030 and
4936RPZ0010M).
In this version of the machine threaded
studs have been replaced with threaded
bushings.
Apply a closing force of 40 Nm on each
bolts for fixing firmly the motor’s support.
Resume from the point 5.g of the
previous chapter for finalizing the
adjustment and the installing.
6. INSTALLATION - ELECTRIC
COMPONENTS
The wiring to control the two contactors
for the left and right rotation is part of this
kit.
a) Open the back electric board
where are the located contactor
“VE” and the fan motor thermal
“RMVE”
b) Next to the “RMVE” contactor
install the two contactors “SX” (left)
and “DX” (right).
c) ATTENTION: the contactor “SX”,
must be installed upside-down.
d) Install the equipotential bar to
connect the main terminals which
are commanding the three phases
a shown in the picture.
To Next Page
Loading...
