Imesa ES7PEE - Follow These Instructions

24
Door hanging
You can choose whether the door is hung on the
right or the left.
Follow these instructions:
1. Remove the plinth.
2. Remove the hinge, two screws.
3. Lift the door up and remove it. Support the
door at the same time.
4. Remove both door pins (top and bottom). Fit
them on the other side of the machine. Ret
the hinge.
5. Loosen the screws (13 in total) on the inside
of the door.
6. Loosen the inner part of the door (pull down
and lift out).
7. Switch the catch (magnetic lock) and the
cover plate. First loosen the screw holding
the catch (magnetic lock) in place. Then use
a at-bladed screwdriver to remove the cover
plate. Ret the catch (magnetic lock) and the
cover plate on the other side.
8. Reattach the inner part of the door with the
screws (13 in total).
9. Move the plastic plugs on the upper and
lower edges of the door. Use a at-bladed
screwdriver to remove the plugs.
10. Loosen the two screws holding the handle
in place on the door. Push out the two plastic
plugs inside the screw holes on the other side
of the door. Use the two screws to attach the
handle to the other side of the door and press
the plastic plugs into the holes where the
handle was previously tted.
11. Ret the door by loosening the hinge screws
slightly, axing the door and closing it.
Retighten the hinges. Replace the plinth.