Imesa RC30 - Page 32

E190601X rev.6_ENG May 30, 2022
32
COD
DESCRIPTION
WHAT HAPPENED: WHAT TO DO
12
CENTRIFUGAL WATER
Although the machine must increase the number of revolutions, the speed
always remains fixed at 100rpm: this is not an alarm but the intervention of a
safety that occurs when the water level, during the start of the centrifuge, does
not fall below the expected level.
Call the Authorized Service Center.
13
OVERHEATING
A display appears: "ALARM !!! 13 Overheating".
The water temperature exceeded 110°C.
The heating system is turned off and the subsequent heating steps are
skipped.
Call the Authorized Service Center.
14
MAINTENANCE
REQUEST
"Maintenance request" appears on the display.
The machine has reached the number of cycles that require the verification of
ordinary maintenance by the Authorized Service Center.
15
WDT ZERO ENGINE
A display appears “WDT Zero Engine".
The maximum time for the opening of the motorized porthole has been
exhausted: call the Authorized Service Center.
16
WDT DOOR CLOSURE
The display displays "WDT Door Closure".
The maximum time for the closure of the motorized porthole has been
exhausted: call the Authorized Service Center.
17
WDT DOOR OPENING
"WDT Door Opening" appears on the display.
The maximum time for the start of the opening of the motorized porthole has
been exhausted: call the Authorized Service Center.
18
WDT INFLATION
A display appears "ALARM !!! 18 Expired WDT gasket inflation".
The maximum time for the completion of the inflation of the porthole gasket
has been exhausted: call the Authorized Service Center.
19
WDT DEFLATION
A display appears "ALARM !!! 19 Expired WDT deflating gasket".
The maximum time for the completion of the deflation of the porthole gasket
has been exhausted: call the Authorized Service Center.
21
...
28
TANK 1 ... 8 OUT OF
STOCK
A display appears "TANICA 1 ... 8 SOLD OUT".
One of the detergent tanks (from 1 to 8 depending on those actually present)
has run out. Fill or replace.
-
POWER FAILURE
"POWER FAILURE" appears on the display.
During the execution of a program, the power supply was lost. When the power
supply is restored, the machine waits for 40" while the display flashes the
words "POWER FAILURE". It is possible to restart the cycle from the point
where it was interrupted, by pressing the "START" icon.
For any other type of message not in the table, refer to the manufacturer's website.