Watch out for erroneous measurement results if the product has been dropped or
has been misused, modified, stored for long periods or transported. Precautions:
Periodically carry out test measurements and perform the field adjustments
indicated in the user manual, particularly after the product has been subjected to
abnormal use and before and after important measurements.
Because of the risk of electrocution, it is dangerous to use poles and extensions in
the vicinity of electrical installations such as power cables or electrical railways.
Precautions: Keep at a safe distance from electrical installations. If it is essential to
work in this environment, first contact the safety authorities responsible for the
electrical installations and follow their instructions.
With the remote control of products, it is possible that extraneous targets will be
picked out and measured.
Precautions:
When measuring in remote control mode, always check your results for plausibility.
If the product is used with accessories, for example masts, staffs, poles, you may
increase the risk of being struck by lightning.
Precautions:
Do not use the product in a thunderstorm.
Inadequate securing of the working site can lead to dangerous situations, for
example in traffic, on building sites, and at industrial installations.
Precautions:
Always ensure that the working site is adequately secured. Adhere to the
regulations governing safety and accident prevention and road traffic.
If the accessories used with the product are not properly secured and the product
is subjected to mechanical shock, for example blows or falling, the product may be
damaged or people can sustain injury.
Precautions:
When setting-up the product, make sure that the accessories are correctly
adapted, fitted, secured, and locked in position. Avoid subjecting the product to
mechanical stress.
During the transport, shipping or disposal of batteries it is possible for inappropriate
mechanical influences to constitute a fire hazard.
Precautions:
Before shipping the product or disposing of it, discharge the batteries by running
the product until they are flat. When transporting or shipping batteries, the person
in charge of the product must ensure that the applicable national and international
rules and regulations are observed. Before transportation or shipping contact your
local passenger or freight transport company.
During dynamic applications, for example stakeout procedures there is a danger of
accidents occurring if the user does not pay attention to the environmental
conditions around, for example obstacles, excavations or traffic.
Precautions:
The person responsible for the product must make all users fully aware of the
existing dangers.
If you open the product, either of the following actions may cause you to receive an
electric shock.
• Touching live components
• Using the product after incorrect attempts were made to carry out repairs
Precautions:
Do not open the product. Only Imex service workshops are entitled to repair these
products.
To Next Page
Loading...
