imex i88G - Imex Laser Battery Handling; Battery Specifications; Battery Charging Instructions; Battery Installation and Reset

Page | 6
Using Wind
Mode

To activate wind mode, turn laser on and allow to self-level
 Once laser is level and spinning, press Wind mode button (e),
and wind mode indicator light will light and wind mode is
activated.
 To turn Wind mode off press Wind mode button (e) wind mode
light will turn off and laser will return to self-levelling mode
Note, Wind mode and TWS mode cannot be used
simultaneously as they have opposite operation function
2.
6
RPM (
Variable Rotation Speed
)
mode
RPM Mode
If a slower speed is required i.e. for visibility; press the RPM
button (j). Speed will revert to 0 RPM, press button again for
60rpm, again for 120rpm and again for 300rpm and again for
800rpm
2.7 Scan Mode
Description of
Scan Mode
The Scan mode allows the laser beam to emit only in a restricted
radius, instead of a full rotation the laser scan from left – right to
for a horizontal line between 10˚-180˚
Using Scan
Mode

Turn the i88R/G on and allow self-level.
 Press the Scan button (h) to activate scan mode. Scan mode
will activate and revert to 0˚ scan.
 To adjust scan width, press the scan button again and scan wil
widen to 10˚, press button again to increase scan to 45˚, 90˚
and 180˚
 To move laser scan line from left to right, press the left and
right scan direction arrows (d)
 To exist Scan mode press the RPM button (j) and laser will
begin to rotate again.