Immergas CARV2 - Summer Mode Functions; DHW Temperature Setting; DHW Timer (for storage tank unit)

15
5. SUMMER MODE FUNCTIONS
With the CAR
V2
remote control in summer mode ( ), only
the production of DHW is enabled.
The boiler produces hot water according to the DHW
temperature set on the CAR
V2
remote control.
5.1 DHW temperature setting.
By turning the selector ( ) it is possible to set the
temperature of the DHW (see g. 12).
By turning in a clockwise direction the temperature
increases and in an anti-clockwise direction it decreases.
e temperature is memorised aer the selector remains
still for a few seconds.
Fig. 12
5.2 DHW timer (for storage tank unit).
If the temperature of the DHW contained in the DHW
storage tank on two distinct levels (comfort and minimum)
is to be regulated, this is possible using the “HW PRG”
function. Regarding this, see the activation mode in the
chapter relative to programming.
The “comfort” temperature corresponds to the value
regulated on the DHW selector. e “minimum” temperature
corresponds to the minimum DHW value envisioned for the
boiler to which the CAR
V2
remote control is coupled.
N.B.: if the CAR
V2
remote control is functioning at
minimum temperature level it is possible to force the DHW
temperature by acting on the DHW selector.
e CAR
V2
remote control is factory set with the DHW
always activated on "comfort" temperature (ON1 00.00
OFF1 24.00).