Immergas VICTRIX PRO V2 EU - Page 132

VICTRIX PRO V2 EU
132
INITIAL OPERATION/ INITIAL CONFIGURATION
DESCRIPTIONS
e heatapp! WLAN-Stick, or simply stick, is used if a per-
manent connection to the home network via a network cable
is not possible.
A Wi-Fi connection to the home network is then made via
the USB stick.
CONNECTING THE HEATAPP! STICK
Connect the WLAN heatapp! stick to the USB port of the
Cascade and zone regulator terminal board.
A local WiFi name is created.
Instructions:
• e Wi-Fi stick must remain plugged in to ensure the correct
functioning of heatcon!
• You require the access data of the Wi-Fi network for the
following set-up steps.
• Changes to the Wi-Fi network (new router, dierent pass-
word, etc.) can impair the operation of heatapp! and may
require resetting of the heatapp! conguration.
INITIAL OPERATION
Select the wireless settings of your tablet/smartphone.
• Connect to the WiFi network created by heatcon!
• Depending on the settings of your tablet/smartphone, the
browser will either open automatically or you open the browser
on your device and enter 10.0.0.1 in the address line.
• Follow the installation wizard instructions.
• Remove the installation stick at the end of the installation
wizard.
TECHNICAL DATA
Wi-Fi 802.11b/g/n
Chip set Coupled to heatapp!
Ambient conditions
• Storage temperature -25 ... +60 °C
• Operating temperature -10 ... +50 °C
Weight Approx. 20 g
USING HEATAPP! APP
To check the system remotely, the specic heatapp! application
must be downloaded on an Android or iOS device.
Only one prole can be entered for each device.
e app provides instructions useful for the customer to start
using the heatapp! system by helping them to install the app on
their own mobile device and guiding them through the rst few
steps in using the app.
e heatapp! system can also be accessed from the Internet
through the LAN network, but not using the “User” prole.
From APP ("Owner" or "Expert" prole) and from Browser
there are many common functions. From the APP you cannot
perform the initial NETWORK conguration, complete mon-
itoring is not available, the “group of rooms” temperatures can
be set, while the “group of rooms” temperatures cannot be set
from the browser, but the browser has complete monitoring
and the initial network conguration can be performed.