What to do if Immergas Boiler shows insufficient system pressure?
If your Immergas Boiler displays insufficient system pressure, it means water pressure inside the central heating system is not detected. Check the boiler manometer bar and restore the correct pressure if necessary.
How to fix overheating block on Immergas VICTRIX X 12-24 2I?
To eliminate the overheating block on your Immergas Boiler, press the Reset button (3).
How to fix no ignition block on Immergas Boiler?
To eliminate the 'no ignition block' error on your Immergas Boiler, press the Reset button (3).
How to fix fan anomaly on Immergas VICTRIX X 12-24 2I?
To eliminate the fan anomaly on your Immergas Boiler, press the Reset button (3). This issue is caused by a mechanical or electrical fault.
How to fix block due to loss of continuous flame signal on Immergas Boiler?
To eliminate the block on your Immergas Boiler, press the Reset button (3). This block occurs when the 'Flame signal loss' error happens 6 times consecutively in 8.5 minutes.
How to fix flue safety thermostat block on Immergas VICTRIX X 12-24 2I Boiler?
To eliminate the flue thermostat block on your Immergas Boiler, press the Reset button (3). This issue is due to partial internal obstruction (from lime scale or mud) or external blocking.
How to fix block due to flue gas temperature gradient intervention on Immergas Boiler?
To eliminate the block due to flue gas temperature gradient intervention on your Immergas Boiler, press the Reset button (3). This issue is caused by a blocked pump or lack of water in the heat exchanger.
What to do if Immergas VICTRIX X 12-24 2I lost Remote Control communication?
If your Immergas Boiler lost Remote Control communication, remove and re-apply voltage to the boiler to reset the error code. This happens due to communication loss between the boiler and the remote control.
What happens when Immergas VICTRIX X 12-24 2I has low power supply voltage?
If your Immergas Boiler experiences low power supply voltage, the boiler will restart automatically without needing a reset once normal conditions are restored. This happens when the power supply voltage is lower than the allowed limits.
What happens if Immergas VICTRIX X 12-24 2I loses flame signal?
If your Immergas Boiler loses flame signal, it will attempt a new ignition. If normal conditions are restored, the boiler does not have to be reset. This occurs when the burner flame switches off unexpectedly.
Guidelines for safe and correct boiler wall or recess frame installation.
Guidelines for installing Immergas flue systems and components.
Requirements for outdoor placement in protected areas.
Instructions for outdoor installation using a recess frame with direct air intake.
Guidelines for indoor installation, including flue systems.
Procedures for ducting flue gases through technical slots.
Procedures for boiler start-up and initial checks.
Important safety warnings regarding boiler operation and use.
Instructions for operating the boiler in summer and winter modes.
Table and explanation of error codes and their meanings.
Information about the anti-freeze function and protection measures.
Common problems and their potential causes and solutions.
Procedure for converting the boiler to different types of gas.
Steps to adjust the air-gas ratio for efficient combustion.
Guide to programming the boiler's printed circuit board parameters.
Annual checks and maintenance procedures for the appliance.
General| Category | Boiler |
|---|---|
| Type | Condensing |
| Power output | 12-24 kW |
| Heat Output (max) | 24 kW |
| Protection rating | IPX5D |
| Ignition | Electronic |
| Heat exchanger material | Stainless Steel |
| Fuel | Natural Gas, LPG |
| NOx class | 6 |
| Water pressure | 3 bar |
To Next Page