What to do if my Immergas VICTRIX 24 kW X Boiler has repeated ignition blocks?
Repeated ignition blocks can occur due to several reasons. First, check the correct L and N polarity of the electrical feed. Also, ensure that there is gas supply by checking the pressure in the mains and verifying that the gas supply cock is open. Finally, the gas valve adjustment could be incorrect, so check its setting.
Why does my Immergas VICTRIX 24 kW X Boiler temperature overload thermostat activate frequently?
Frequent activation of the temperature overload thermostat may be due to a few reasons. It could be caused by a lack of water in the boiler; check the pressure gauge to ensure values are within admissible limits. Another cause might be insufficient water circulation in the circuit, so check that radiator valves are not all closed. Finally, a blocked circulator could be the culprit, so verify that the circulating pump is working correctly.
How to resolve irregular combustion or noisiness in my Immergas Boiler?
Irregular combustion or noisiness may be due to a dirty burner, so you should clean the burner. Incorrect combustion parameters or an incorrectly installed intake-exhaust terminal can also cause these issues. Ensure correct installation of the terminal, check the correct setting of the gas valve (Off-Set setting), and verify the correct percentage of CO2 in fumes.
How to remove air noise from my Immergas Boiler system?
To address noise due to air in the system: * Check the opening of the cap on the special air valve. * Check that system pressure and the expansion tank precharge are within the set limits. * Ensure the expansion tank precharge value is 1.0 bar, and the system pressure is between 1 and 1.2 bar.
Detailed overview of the VICTRIX 24 kW X boiler's general characteristics and capabilities.
Detailed explanation of the VICTRIX 24 kW X boiler's hydraulic system and component flow.
How the secondary circuit operates for domestic hot water requests, prioritizing DHW.
How the fan, valve, Venturi, and burner interact for combustion.
Procedure for adjusting the boiler's heat output and fan speed.
Fine-tuning the air-gas ratio based on CO₂ measurements.
Steps for calibrating the gas valve for CO₂ levels according to serial number.
How to adapt the gas valve for different gas types and calibrate CO₂.
How the fan, heat exchanger, and flue hood manage combustion gases.
Diagram and explanation of the 230V AC electrical circuit of the boiler.
Overview of safety devices and controls integrated into the electrical system.
Description of the integrated P.C.B. controlling boiler functions.
Overview of safety devices and controls operating on low voltage.
Operation of the main selector switch for different boiler modes.
Display of functioning values, error codes, and status symbols.
General operation of the integrated P.C.B. for boiler functions.
Sequence of operations when a central heating request is made.
Sequence of operations for the boiler in domestic hot water mode.
How instant boilers respond to DHW withdrawal requests.
How boilers with storage tanks handle DHW requests.
Boiler operation during central heating or DHW anti-freeze conditions.
How to activate the chimney sweep function and its operation.
Activates boiler modes and allows reset/calibration.
Blocks operation if water overheating safety thermostat opens.
Blocks operation if flue safety thermostat opens due to impurities.
Boiler functioning is blocked if flame is not detected within 10 seconds.
Blocks burner if temperature increases rapidly due to low circulation.
Boiler functioning is blocked if ionization current is detected without gas valve open.
Blocks burner if fan speed is outside safe limits.
To Next Page
General