What does block gas valve control mean on Immergas VICTRIX 24 TT 2 ERP Boiler?
If your Immergas Boiler displays a 'Block - gas valve control', it means a malfunction of one of the components that controls the gas valve has been detected and the boiler does not start.
What to do if Immergas Boiler shows insufficient system pressure?
If your Immergas Boiler displays an 'Insufficient system pressure' error, it means the water pressure inside the central heating circuit isn't sufficient for correct operation. Check the boiler pressure gauge and ensure the system pressure is between 1 and 1.2 bar. If necessary, restore the pressure to this range.
Why does my Immergas Boiler have a loss of flame signal?
If your Immergas Boiler experiences a 'Loss of flame signal', it means the burner flame switched off unexpectedly after correct ignition. The boiler will automatically attempt a new ignition. If normal conditions are restored, the boiler restarts without needing a reset.
What happens if Immergas VICTRIX 24 TT 2 ERP reaches maximum number of resets?
If your Immergas Boiler signals a 'Maximum N° of reset', note that the anomaly can be reset 5 times consecutively, after which the function is inhibited for at least one hour. One attempt is gained every hour for a maximum of 5 attempts. By switching the appliance off and on again, the 5 attempts are re-acquired.
What to do if my Immergas Boiler shows a safety thermostat block (over-temperature)?
If your Immergas Boiler displays a safety thermostat block (over-temperature) during normal operation due to excessive internal overheating, press the Reset button (1).
What does 'Contacts resistance block' mean on my Immergas VICTRIX 24 TT 2 ERP Boiler, and how can I resolve it?
If your Immergas Boiler shows a Contacts resistance block, it means the P.C.B. detects an anomaly on the gas valve supply. Check the connection and press the Reset button (1). Note that the anomaly is detected and displayed only when there is a request.
How do I fix a flue safety thermostat block on my Immergas VICTRIX 24 TT 2 ERP Boiler?
To address a 'Flue safety thermostat block' on your Immergas Boiler, press the Reset button.
What does domestic hot water probe anomaly mean on Immergas VICTRIX 24 TT 2 ERP?
If your Immergas Boiler displays a 'Domestic hot water probe anomaly', it means the board detects an anomaly on the domestic hot water NTC probe. In this case, the boiler continues to produce domestic hot water but not with optimal performance.
What does contacts resistance block mean on Immergas Boiler?
If your Immergas Boiler is experiencing a 'Contacts resistance block', it means the P.C.B. detects an anomaly on the gas valve supply. Press the Reset button to attempt to resolve the issue.
What does configuration error mean on Immergas Boiler?
If your Immergas Boiler displays a 'Configuration error', it means the board detects an anomaly or incongruity in the electric wiring. The boiler will not start. If normal conditions are restored, the boiler restarts without needing a reset. Check that the boiler is configured correctly.
General| Type | Condensing Boiler |
|---|---|
| Mounting | Wall-mounted |
| Power Output | 24 kW |
| Heating Output | 24 kW |
| DHW Output | 24 kW |
| Fuel Type | Natural gas / LPG |
| Efficiency Class Heating | A |
| Efficiency Class DHW | A |
| Weight | 32 kg |
| Control | Electronic |
| Modulation | 1:10 |
| Electrical protection class | IPX5D |
| Operating pressure | 3 bar |
To Next Page