How to fix no ignition block on Immergas VICTRIX MAIOR 35 X TT 1 ERP Boiler?
If your Immergas Boiler fails to ignite when central heating or domestic hot water is requested (when connected to an external storage tank unit), try pressing the Reset button.
What to do if Immergas VICTRIX MAIOR 35 X TT 1 ERP Boiler has safety thermostat block (over-temperature)?
If your Immergas Boiler experiences an overheating block due to a fault causing excessive internal overheating during normal operation, press the Reset button.
How to resolve fan anomaly in Immergas Boiler?
If your Immergas Boiler displays a fan anomaly, which may be due to a mechanical or electrical fault, try pressing the Reset button.
What causes parasite flame block in Immergas VICTRIX MAIOR 35 X TT 1 ERP and how to fix it?
A parasite flame block in your Immergas Boiler can occur due to a leak in the detection circuit or an anomaly in the flame control unit. To resolve this, press the Reset button.
What to do if Immergas VICTRIX MAIOR 35 X TT 1 ERP Boiler shows flue safety thermostat block?
If your Immergas Boiler blocks due to excessive flue gas overheating during normal operation, press the Reset button.
How to fix block due to loss of flame signal on Immergas Boiler?
If your Immergas Boiler blocks due to repeated flame signal loss within a short period, press the Reset button. Before restarting, the boiler will run a post-ventilation cycle.
What happens if Immergas VICTRIX MAIOR 35 X TT 1 ERP Boiler has low power supply voltage?
If your Immergas Boiler experiences low power supply voltage, which is below the allowed limits for correct operation, it should restart automatically once normal conditions are restored without needing a reset.
How to remove air from circulator pump in Immergas VICTRIX MAIOR 35 X TT 1 ERP Boiler?
If air is detected inside the circulator pump of your Immergas Boiler, vent the pump and the central heating circuit. The boiler should restart once normal conditions are restored without needing a reset.
What to do if Immergas VICTRIX MAIOR 35 X TT 1 ERP Boiler pump is blocked?
If the pump in your Immergas Boiler is blocked due to an impeller blockage or electrical fault, try to unblock the pump as described in the relevant section. The boiler should restart automatically once normal conditions are restored without needing a reset.
What causes high flow probe deviation in Immergas VICTRIX MAIOR 35 X TT 1 ERP?
If your Immergas Boiler detects a deviation in the temperature readings of the NTC flow probes, which may be due to a faulty probe, incorrect position, poor system circulation, or clogging of the water side primary heat exchanger, the boiler should restart once normal conditions are restored without needing a reset.
General guidelines for safe and proper boiler placement and environmental considerations.
Instructions for safely connecting the gas supply to the boiler.
Guidance on correctly connecting the boiler to heating and hot water circuits.
Steps and safety precautions for connecting the boiler to the power supply.
Steps for initial boiler ignition and commissioning.
Outlines necessary cleaning and annual maintenance for optimal performance.
Provides a guide to error codes and their causes/solutions.
Lists common issues, their causes, and solutions during commissioning.
Detailed steps for performing a full boiler calibration.
Guide to accessing and modifying boiler operating parameters via the PCB.
Routine checks and maintenance tasks for the year.
To Next Page
General