What to do if Immergas VICTRIX MAIOR 35 X TT 1 ERP shows insufficient system pressure?
If your Immergas Boiler indicates insufficient system pressure, check the boiler pressure gauge to ensure the system pressure is between 1 and 1.2 bar. If necessary, restore the pressure to the correct level.
Why is my Immergas Boiler showing combustion anomaly?
If your Immergas Boiler detects low supply pressure on the gas line, it will limit the appliance power and report a combustion anomaly. The boiler should restart once normal conditions are restored without needing a reset.
What to do if Immergas Boiler loses communication with CARV2?
If your Immergas Boiler loses communication with the CARV2 (remote control) due to an incompatible remote control or loss of communication, power cycle the boiler. If the remote control is still not detected upon restart, the boiler will switch to local operating mode, using the controls on the control panel. In this case, the 'Central Heating' mode cannot be activated.
General guidelines for safe and proper boiler placement and environmental considerations.
Instructions for safely connecting the gas supply to the boiler.
Guidance on correctly connecting the boiler to heating and hot water circuits.
Steps and safety precautions for connecting the boiler to the power supply.
Steps for initial boiler ignition and commissioning.
Outlines necessary cleaning and annual maintenance for optimal performance.
Provides a guide to error codes and their causes/solutions.
Lists common issues, their causes, and solutions during commissioning.
Detailed steps for performing a full boiler calibration.
Guide to accessing and modifying boiler operating parameters via the PCB.
Routine checks and maintenance tasks for the year.
To Next Page
General