To Next PageTo Next PageWhat to do if my Immergas VICTRIX 24 kW X Boiler has repeated ignition blocks?
Repeated ignition blocks can occur due to several reasons. First, check the correct L and N polarity of the electrical feed. Also, ensure that there is gas supply by checking the pressure in the mains and verifying that the gas supply cock is open. Finally, the gas valve adjustment could be incorrect, so check its setting.
Why does my Immergas VICTRIX 24 kW X Boiler temperature overload thermostat activate frequently?
Frequent activation of the temperature overload thermostat may be due to a few reasons. It could be caused by a lack of water in the boiler; check the pressure gauge to ensure values are within admissible limits. Another cause might be insufficient water circulation in the circuit, so check that radiator valves are not all closed. Finally, a blocked circulator could be the culprit, so verify that the circulating pump is working correctly.
How to resolve irregular combustion or noisiness in my Immergas Boiler?
Irregular combustion or noisiness may be due to a dirty burner, so you should clean the burner. Incorrect combustion parameters or an incorrectly installed intake-exhaust terminal can also cause these issues. Ensure correct installation of the terminal, check the correct setting of the gas valve (Off-Set setting), and verify the correct percentage of CO2 in fumes.
How to remove air noise from my Immergas Boiler system?
To address noise due to air in the system: * Check the opening of the cap on the special air valve. * Check that system pressure and the expansion tank precharge are within the set limits. * Ensure the expansion tank precharge value is 1.0 bar, and the system pressure is between 1 and 1.2 bar.
General