How to fix insufficient circulation on Immergas VICTRIX X 12-24 2I?
If your Immergas Boiler has insufficient circulation, check that no shut-off devices are closed on the heating circuit and that the system is free of air (deaerated); free the circulating pump. This is caused by overheating in the boiler due to insufficient water circulating in the primary circuit.
How to fix block for maximum time, gas valve opening on Immergas Boiler?
To eliminate the block for maximum time, gas valve opening on your Immergas Boiler, press the Reset button (5). This issue occurs when the gas valve remains open for a time longer than that envisioned for normal functioning.
What to do if Immergas VICTRIX X 12-24 2I Boiler shows configuration error?
If your Immergas Boiler shows a configuration error, the boiler restarts without needing a reset if normal conditions are restored. This is due to an anomaly or incongruency on the electric wiring.
General| Category | Boiler |
|---|---|
| Type | Condensing |
| Power output | 12-24 kW |
| Heat Output (max) | 24 kW |
| Protection rating | IPX5D |
| Ignition | Electronic |
| Heat exchanger material | Stainless Steel |
| Fuel | Natural Gas, LPG |
| NOx class | 6 |
| Water pressure | 3 bar |
Guidelines for safe and correct boiler wall or recess frame installation.
Guidelines for installing Immergas flue systems and components.
Requirements for outdoor placement in protected areas.
Instructions for outdoor installation using a recess frame with direct air intake.
Guidelines for indoor installation, including flue systems.
Procedures for ducting flue gases through technical slots.
Procedures for boiler start-up and initial checks.
Important safety warnings regarding boiler operation and use.
Instructions for operating the boiler in summer and winter modes.
Table and explanation of error codes and their meanings.
Information about the anti-freeze function and protection measures.
Common problems and their potential causes and solutions.
Procedure for converting the boiler to different types of gas.
Steps to adjust the air-gas ratio for efficient combustion.
Guide to programming the boiler's printed circuit board parameters.
Annual checks and maintenance procedures for the appliance.
To Next Page