Need help?Do you have a question about the Immergas VICTRIX ZEUS 20 and is the answer not in the manual?
Condensation-type wall-hung boiler with Gaudium Magnum device for efficient operation.
Technical drawing showing the main physical dimensions of the boiler.
Details of the boiler's control panel, indicators, and buttons.
Description of the primary circuit with control and safety devices.
Explains the role and connection of the circulator in the primary circuit.
By-pass, filling unit, and expansion vessel for system safety.
No-water pressure switch and 3-bar safety valve for system protection.
Automatic air vent for releasing gaseous substances.
Explains the operation of the secondary circuit for domestic hot water.
Anode and optional polyphosphate unit for tank protection.
Gaudium Magnum and flow limit thermostat for water management.
NTC sensor and safety valve unit for monitoring and protection.
Re-circulation kit for connecting D.H.W. systems.
Details how the Gaudium Magnum device operates to manage hot water flow.
Explains the operation and movement of the motorised 3-way valve.
Description of the gas valve, its coils, and pneumatic unit.
Details the pneumatic unit for air-gas mix pressure control.
The role and control of the fan in air intake and mixing.
How the Venturi pipe mixes air and gas via the Venturi effect.
Description of the burner's construction and combustion performance.
Role of ignition electrodes in igniting the air-gas mix.
How the detection electrode confirms flame presence and safety.
Procedure for adjusting nominal and minimum heat output.
How to adjust the air-gas ratio (off-set) for optimal combustion.
Draught diverter and condensation runoff syphon.
Venturi pressure points and air/fume sampling trap.
Installation requirements for fan-assisted sealed chamber configuration.
Installation requirements for fan-assisted open chamber configuration.
Details of the 60/100 slot-in horizontal eccentric kit.
Details of the 80/80 slot-in separator kit.
Details of the 60/100 slot-in vertical concentric kit.
Instructions for using 60mm rigid pipes with condensation boilers.
Instructions for using 80mm flexible pipes with condensation boilers.
Electrical diagram for the 230V AC power supply.
Identification of electrical safety devices and checks.
Ignition control unit and modulating control board functions.
Circulator and ignition electrodes for system operation.
Gaudium Magnum valve and indicator light.
Transformer for low-voltage adjustment circuit.
Zone control, remote control, and external sensors.
Heating and domestic hot water NTC sensors.
No-water safety device for pump and ignition protection.
Electrical circuit diagram specific to the heating phase.
Operation with room thermostat and remote control in heating.
Electrical circuit diagram specific to the domestic hot water phase.
Operation for domestic hot water requests.
How the control board manages heating requests.
Procedures for domestic hot water and antifreeze requests.
Activation and operation of the chimneysweep function.
Circulator antilock, post-circulation, and post-ventilation.
Ignition failure, overtemperature, and sensor breakage locks.
Safety device for monitoring fan speed.
Meaning of the DL1, DL2, and DL3 status LEDs.
Information shown on the digital display, including error codes.
Step-by-step sequence for heating mode operation.
Step-by-step sequence for D.H.W. mode operation.
Technical data for the VICTRIX Zeus 20 model.
Technical data for the VICTRIX Zeus 27 model.
Heat output performance data for VICTRIX Zeus 20.
Heat output performance data for VICTRIX Zeus 27.
To Next Page
General