STEP 5 (See Diagram 5)
A.) Attach the Rear Vertical Frame (#6) onto the Rear Base (#16). Secure it with two M10 x 2
¾” Carriage Bolts (#85) from the bottom, two ∅ ¾” Washers (#80) and two M10 Aircraft
Nuts (#82) on the top. Slide the Sliding Weight Post (#11) onto the Rear Vertical Frame
from the top.
B.) Place the Rear Base (#16) in between the two Rear Left & Right Stabilizers (#7 & #8).
Attach the Front Vertical Frame (#9) onto the Rear Base (#16). Align the holes and secure
them all together with two M10 x 3 1/8” Carriage Bolts (#88), ∅ ¾” Washers (#80), and
M10 Aircraft Nuts (#82).
C.) Slide the Sliding Pulley Bracket (#17) onto the Front Vertical Frame (#9). Use a Lock Knob
(#68) to lock the Sliding Pulley Bracket at selected position.
D.) Secure the Front Vertical Frame (#9) to the Rear Cross Brace (#5) with two M10 x 2 ¾”
Carriage Bolts (#85), one 4 ¾” Bracket (#27), two ∅ ¾” Washers (#80), and two M10
Aircraft Nuts (#82).
E.) Attach the Upper Frame (#10) to the top of Front Vertical Frame (#9). Secure it with two
M10 x 5/8” Allen Bolts (#98) and ∅ ¾” Washers (#80).
F.) Attach the rear of Upper Frame to the top of Rear Vertical Frame (#6). Secure it with one
M10 x 2 3/8” Allen Bolt (#95), ∅ ¾” Washer (#80) and 3 1/8” Bracket (#28) to the top hole.
Secure the bottom hole with one M10 x 2 ½” Carriage Bolt (#84), ∅ ¾” Washer (#80), and
M10 Aircraft Nut (#82).
G.) Securely tighten all Nuts and Bolts previously installed.
12
To Next Page
Loading...
