Beach Mountain AS - 13 - fitness@beach-mountain.no
2-6 Running Belt Adjustment
After installing and leveling the treadmill, check the belt to ensure that it is tracking properly.
First, plug the power cord into an appropriate dedicated outlet. Then, turn the treadmill ON. Have one
person stand on the anti-slip pads on either side of the treadmill frame. Do not stand on the running belt at
this time. Press the QUICK START key, and increase the speed to 4.0 mph(6.4 kph).
If the striding belt moves to the right while it is running:
Turn the right tension bolt a quarter-turn clockwise, and then turnthe left tension bolt(A) a quarter-turn
counter-clockwise. See the illustration below. Allow the treadmill to run for 5 minutes. This action
should set the striding belt tracking back to center of the roller, if not, repeat process.
If the striding belt moves to the left while it is running:
Turn the left tension bolt (A) a quarter-turn clockwise and then turn the right tension bolt a quarter-turn
counter-clockwise. Allow the treadmill to run for 5 minutes. This action should set the striding belt
tracking back to center of the of the roller, if not, repeat process.
NOTE: Do not exceed one full turn of the adjusting screws in either direction. If, after one full turn, the
belt does not track properly, check with a qualified service company.
To Next Page
Loading...
Need help?
General
