Beach Mountain AS - 18 - fitness@beach-mountain.no
2. Place the Computer Shelf(A) on the assembled Uprights(C,D) of Frame(B) and pull the control wire into the
upright to connect it with the computer. Put the computer shelf above the uprights and tighten with Nylon
Nuts(b) as shown in the above drawing. Tighten the computer with plastic handle screws(d). Lastly, install
the copholders.
Note：(1) When tightening the screws, pay attention to whether the control wire in the tube pinched.
(2) When connecting the control wires, pay attention whether the corresponding color is correct, red
matches with red and white matches with white.
To Next Page
Loading...
