19
Assembly
STEP 4
1. Attach two Foam Tube ASSYS (#13) to the Swing Frame ASSY (#9).
2. Attach four Short Foams (#18) to two Foam Tube ASSYS (#13) using:
four Ring Φ60*Φ26*12 (#22) four Cap ASSYS (#21)
four M10*35 SHCS (#29)
3. Attach the Seat Pad (#17) to the Sliding Rack ASSY (#6) using:
two M10*75 SHCS (#27) two Φ11*Φ20*2 Flat Washer (#35)
4. Attach the Back Pad (#16) to the Back Pad Frame (#7) using:
two M10*30 SHCS (#30) two Φ11*Φ20*2 Flat Washer (#35)
two Plug Φ31.5*18 (#24)
Note: Wrench Tighten Bolts and Nylon Lock Nuts.
To Next Page
Loading...
