Indesit BTW A51052 - Troubleshooting; Common Anomalies and Solutions; Specific Troubleshooting Scenarios

EN
User manual
13
CLEANING THE MESH FILTERS IN THE WATER SUPPLY HOSE
1. Close water tap and unscrew the inlet hose.
2.
1
2
Clean the mesh lter at the hose’s end carefully with a
ne brush.
3. Now unscrew the inlet hose on the back of the washing
machine by hand. Pull out the mesh lter from the valve
on the back of the washing machine with pliers and
carefully clean it.
4. Insert the mesh lter again. Connect the inlet hose to
water tap and washing machine again. Do not use a tool
to connect the inlet hose. Open the water tap and check
that all connections are tight.
2
1
CLEANING THE DETERGENT DISPENSER
Clean the detergent dispenser regularly, at least three or four
times a year, to prevent detergent build-up.
1. Press the release button to release the detergent
dispenser and remove it. A small quantity of water can
remain in the dispenser, thus you should carry it in an
upright position.
2.

Wash the dispenser using running water. You can also
remove the siphon cap on the back of the dispenser
for cleaning. Replace the siphon cap in the dispenser (if
removed)
3. Reinstall the dispenser by locating the dispenser’s bottom
tabs into the appropriate openings on the lid, and by
pushing the dispenser against the lid until it locks into
place.
Make sure that the detergent dispenser is correctly
reinstalled.