User manual
14
CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER
Switch o and unplug the washing machine before cleaning the water lter or draining residual water. If you used a
hot wash programme, wait until the water has cooled down before draining any water.
Clean the water lter regularly, to avoid that the water cannot drain after the wash due to obstruction of the lter.
Especially:
• if the appliance is not draining properly or if it fails to perform spin cycles.
• if the “Clean lter“ indication lights up.
1. Open the lter cover with a coin.
2. Container for the drained water:
Place a low and wide container under the water lter in
order to collect the residual water.
3. Drain the water:
Slowly turn the lter counter-clockwise until all the
water has come out. Allow the water to ow out without
removing the lter. Once the container is full, close the
water lter by turning it clockwise. Empty the container.
Repeat the procedure until all the water has been drained.
4. Remove lter: Lay a cotton cloth beneath the water lter,
which can absorb a small amount of rest water. Then
remove the water lter by turning it out anti-clockwise.
5. Clean the water lter: remove residues in the lter and
clean it under running water.
6. Insert the water lter and close the cover:
Reinsert the water lter again by turning it in clockwise
direction. Make sure to turn it in as far as it goes; the lter
handle must be in vertical position. Pour approximately one
litre of water into the washing machine via the drum and
check that water does not leak from the lter. Close the lter
cover.
1
2
To Next Page
Loading...
