Example: Installation tool (Hainbuch)
Example: Remove clamping element holder and base body
Remove the base body (1) and clamping tube (6) using the installation tool, and
clean.
3. Check clamping tube (6), base body (1), and Glyd ring for damage and wear,
replace if necessary.
4. Clean clamping element holder (2) and collet (4). Grease collet (oil-resistant
grease).
5. Reinstall base body (1) and clamping tube (6). Grease the base body (1) and
clamping tube/thread (6) according to the manufacturer's instructions and
screw them back into the spindle using the installation tool.
6.
Example: Position of base body MS40
Maintenance Summary - Care activities
42
Maintenance Instructions
MS40-6
DIM021EN - 03.06.2020
To Next Page
Loading...
