3-4
Indmar Marine Engines
3. Disengage the shift interlock. Advance the throttle
lever to full throttle and hold. Turn the key to the
START position to clear extra gasoline from the
engine. When the engine starts, immediately return
throttle handle to IDLE position.
4. If it does not start, wait two minutes and try the
sequence again.
ENGINE RESTART
1. If your engine is already warm and will not re-start,
turn key to ON position and wait for about 20
seconds (not necessary with carbureted engine).
2. Make sure that your throttle lever is in NEUTRAL.
3. Turn key OFF. Try to start engine again. If it does
not start disengage the shift interlock and advance
throttle to about 1/4 while holding key in the START
position. When engine starts, release the key and
immediately return throttle to IDLE position.
NOTICE
Your engine is designed to work with the standard
electronics installed in your boat. If you add electrical
components or accessories, you could change fuel
injection controls for your engine or could exceed the
amperage capacity of the wiring and protection
system. Before adding electrical equipment, consult
your Indmar dealer.
OME0502-15 Body.qxp_OM0502-05 Body.qxd 5/20/14 12:45 PM Page 3-4
To Next Page
Loading...
Need help?
General